جديد العربات المقطورة شاحنة قلابة Fliegl TLK 118

Description: Tipper- three-way
Functionality: fully functional
Location: Oberpöllnitzer Straße 8, 07819 Triptis, Deutschland
Suspension: parabolic leaf (spring)
Approval country: Germany
Attention: Archive images!
axle configuration: 2 axles
Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs
Chassis
Steel welded construction
continuous tilting shaft at the rear with 80 mm ball bearing
Gearbox support leg at the front
2 support wedges with holder
Underrun protection
steel
Lockable storage compartment for ramps under the loading area
Coupling device for center axle trailer
Drawbar with tested 40 mm tow hitch
Drawbar height-adjustable via spindle
max. adjustment range 300 mm
Axles + Suspension
Euro axles of our choice
with tapered roller bearings and S-cam brakes
Bscksi Rizbj S Tn Hbodg
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load equalization (lever equalization)
Wheels and Tires
235 / 75 R 17.5
According to the manufacturer's choice
Steel rims
factory silver
Braking System
2-line compressed air braking system
color-coded lines for easy servicing
Hand-operated parking brake
Integral air reservoir
Without ABS
but with mechanical ALB
then max. 60 km/h approval
2 fail-safe coupling heads at the front
with connecting lines to the towing vehicle
Electrical System
12 Volt
multi-chamber lights
without yellow LED lighting on the sides
reflectors on the sides
2 white position lights at the front
2 white/red marker lights at the rear
1 x 7-pole 12 Volt plug at the front
with connecting cable
extended by approx. 60 cm
Three-way tipper
hydraulic multi-piston press with stroke limitation and safety cable
Low-pressure cylinder up to max. 170 bar
without throttle. If required
this must be retrofitted on the truck
Hydraulic connection with SVK plug NW 10/3
incl. connecting hose
Operation hydraulically via truck PTO
Tipping Bridge
Sturdy tipping bridge with 4 mm steel sheet floor
side wall construction steel
side walls continuous
Bed length approx. 4,500 mm
side walls with 5 hinges at the bottom
Bed width 2420 mm
5 pairs of lashing eyes in the floor
each 5 tons
Operating Instructions
The specified total weight is technically possible
but depending on the load
the total weight may not be reached while complying with the permissible axle / support and saddle loads. (Poor driving and handling characteristics possible due to incorrect load distribution)
Approval Country / Signage
With Dekra approval and certificate
for max. 60 km/h approval
towing vehicle LoF (approval country Switzerland max. 40 km/h possible)
Prepared for single-row license plate holder
Without contour marking / reflective stripes according to ECE R 048
Painting
Frame hot-dip galvanized incl. passivation
15-year warranty against rust
Side walls / bridge RAL 3002 carmine red
Note! If the bridge is galvanized
it will not be painted!
Note! Bridge is only primed inside!
Wide tires also possible at an extra cost. 355 / 60 R 18
then loading height approx. 980 mm